Home

Apparel

Hardware

Military

Safety

Security

Security System

Contact

This email address is being protected from spambots. You need JavaScript enabled to view it.

Search

Pedestrian Gates - MPH 112The MPH (Magnetic Pedestrian High Door) Series pedestrian barrier was developed to control the access of persons under medium to high security requirements.

Closure takes place immediately after passage or after an ad- justable hold-open time. The opening and closing times can be programmed to be different from each other, the times depend on the height of the glass flaps. In its initial position the barrier is closed; it can be operated in one direction only, or in both directions.

MPH barriers are available in two versions. The standard ver- sion permits unimpeded passage for persons. The Wide lane has a greater lane width and provides optimum passage for persons with luggage and for wheel chairs.

A line or installation consists of at least two modules.

 

Housing and quality
The housing is made of stainless steel grade 304 (1.4301) and is built up from several segments whose length can be varied to suit the customers requirements. Various optional access-control systems (e.g. card readers) can be readily integrated into the stainless steel front panels. The hous- ing complies with degree of protection IP32 and is suitable for indoor applications, or for outdoor use under a roof (but only with additional heating).

Pedestrian Gates - MPP 112 / 212The MPP series is designed to control pedestrians entering or exiting restricted areas, usually under surveillance, in low security situations. Personal surveillance is therefore recom- mended as the barrier can be breached.

The barrier consists of a rotating center, at 3 x 120 degrees, providing single access through steps of 1 x 120 degrees. The operation of the barrier allows for controlled bi-directional pedestrian flow and is capable of blocking in either direc- tion, or free rotation in either direction.

This model can be used in two directional control applica- tions with a high usage of pedestrian traffic.

 

Housing and quality
The housing of the MPP 112 is made of stainless steel 430 with protection class IP32. The standard type is for indoor installations. Furthermore, for outdoor installations, Magnetic provides a special type model of stainless steel 304 with protection class 44.(MPP 212). For this model, no roofing is required.

Pedestrian Gates - MPR 112The MPR series is designed to control pedestrians entering or exiting restricted areas, usually under surveillance, in low security situations. Personal surveillance is therefore recom- mended as the barrier can be breached.

The aisle is blocked by means of a retractable triangular wing made of an aluminum core construction covered by PU-foam. Alternatively an acrylic glass wing is available. Two different models allow two different passage widths (520mm and 960 - 990mm).

The MPR series can be used in bidirectional applications to control the entry and exit with only one line. A line or instal- lation consists of at least two modules.

 

Housing and quality
The housing made of stainless steel is separated into three segments. The locked middle segment contains the controller and the drive unit. Access control devices (such as card readers, finger print readers etc.) can be installed on a stainless steel fascia panel located at each end segment. These segments also contain the Gate End Displays showing the current operational state to the user. The housing offers protection class IP 32.

Our Location

Rakha Jaya Showroom Pakuwon Trade Centre
LG Floor Block A6 05-06 No 47-48
Jl. Puncak Indah Lontar no 2
Surabaya 60216; Jawa Timur
Indonesia 0812-5900-8093